| Model | SA-2K | SA-3K | SA-4K | SA-10K |
|---|---|---|---|---|
| Body Size (Width, Depth, Height, and Weight) | W580×D350×(H800)(80Kg) | W580×D350×(H800)(80Kg) | W630×D400×(H900)(110Kg) | W820×D600×(H1900)
(300Kg pedestal-integrated) |
| Jig Size (When XYΘ Table is used) | W250～W380×D300 | W250～W380×D300 | W250～W450×D350 | W350～W500×D400 |
| Stroke | 125mm intermediate stop | 125mm intermediate stop | 125mm intermediate stop | 150mm intermediate stop |
| Cylinder diameter | 63mm | 80mm | 100mm | 140mm |
| Pressure (maximum at 6atm) | 180Kgf | 300Kgf | 470Kgf | 920Kgf |
| Table(OP) | XYΘ Table, 1/100 dial gauge | XYΘ Table, 1/100 dial gauge | XYΘ Table, 1/100 dial gauge | XY Table, 1/100 dial gauge |
| Safety Mechanisms | Front Area Sensor(Type4) , Slide Side Window with Limit Switch, Emergency Shutdown Switch | Front Area Sensor(Type4) , Slide Side Window with Limit Switch, Emergency Shutdown Switch | Front Area Sensor(Type4) , Slide Side Window with Limit Switch, Emergency Shutdown Switch | Front Area Sensor(Type4) , Slide Side Window with Limit Switch, Emergency Shutdown Switch |
| Test Jig | The standard height of Jig is 180mm. Other size is accommodated with installation attachments.
If higher than 180mm, we discuss and respond at the order acceptance meeting. Cases for existing jigs can also be responded likewise. |
|||
| Options | Power key switch, Failure buzzer, Rear Safety Cover, Various Test Interfaces, Custom Pedestal,
Z-axis Adjustment Unit: +/-5mm |
|||
To give a high accuracy and wear resistance to the guiding mechanism, the linear shaft undergoes a hard chrome finishing after quenching, and applies the wide size to the guide so that the clearance is suppressed. A plating is applied to the exterior.
The stroke is 125mm, but the intermediate stop sensor (0-125mm, optional) was installed and thus the test cycle time reduced after arrangements.
※ [Reference] While the stroke is 125mm, the time is 2.9sec, the middle setting at 80mm leads to 1.9sec. thus 30% reduction is achieved. (Our measured value and the inspection time 1sec is assumed.)
Sensors’ and cushions’ position adjustments can be done easily by opening the frontal doors.
※ A speed adjustment can also be performed on the front part.
A highly precise XYΦ table has been adopted to achieve a high flatness, low board thickness error, low distortion and high corrosion resistance.
